wcbrown
One of the Regulars
- Messages
- 164
- Location
- New Castle, PA
I would like a bit more cup on my VS Last Man. What is the best way to accomplish this for a novice? Thanks
-
The Fedora Lounge is supported in part by commission earning affiliate links sitewide. Please support us by using them. You may learn more here.
Easiest, least "painful" way to cup a brim...
- Thread starter wcbrown
- Start date
tommyK
One Too Many
- Messages
- 1,789
- Location
- Berwick, PA
Send it back to Art and tell him what you want. It's unlikely you'll be able to do a descent job of it yourself unless you have a brim flange in the size and shape you want. I say this from experience.
- Messages
- 10,524
- Location
- DnD Ranch, Cherokee County, GA
:arated:
wcbrown
One of the Regulars
- Messages
- 164
- Location
- New Castle, PA
Thanks all, I kind of thought that would be the best route.
- Messages
- 10,524
- Location
- DnD Ranch, Cherokee County, GA
I have had good results flattening out a brim on ironing board with a steam iron & a handkerchief.
Guess if you had something close to the shape that you could iron against, that might work for you....
Guess if you had something close to the shape that you could iron against, that might work for you....
- Messages
- 4,118
- Location
- The Beautiful Diablo Valley
When you say "cup" your brim...what exactly are you saying? To give it more "up" curl in the back? Or more snap down in the front?
Either way, do it with a gentle steady steam from a kettle, you know, those "whistling" tea kettles with the narrow spout, which give a wonderful tight stream of steam!
Steam the area of the felt, and by hand, shape the brim to where you want it. Try this first before spending back and forth shipping to Medford.
Either way, do it with a gentle steady steam from a kettle, you know, those "whistling" tea kettles with the narrow spout, which give a wonderful tight stream of steam!
Steam the area of the felt, and by hand, shape the brim to where you want it. Try this first before spending back and forth shipping to Medford.
When reshaping my Akuras, I found that it was easier to prop a hat up against something, so it has the shape I want and then take my small trekking gas with a small kettle and place a plastic tube on the spout and steam the hat with the tube and then just leave it to cool and dry again.
I found it much more difficult to hold the hat over the spout and try to shape it by hand and then hold the shape till the hat is cooled off.
I found it much more difficult to hold the hat over the spout and try to shape it by hand and then hold the shape till the hat is cooled off.
Ordinary Guy
One Too Many
- Messages
- 1,292
- Location
- Pittsburgh, PA
Keep checking ebay there are lots of flanges there for sale and they are great for working on brims
emigran
Practically Family
- Messages
- 719
- Location
- USA NEW JERSEY
It is very hard to let your new hat go but really send it back to Art ... he returns quick fixes like that quickly and you will have no problems...
Similar threads
